STATIONARY GEAR CONSTRUCTION


BHE011010908T06

• The special steel used for the stationary gear is processed with ion nitriding for improved strengthening against fatigue on the tooth surfaces.

• The main bearing is pressed into the stationary gear. Rotation lock of this bearing is done with a screw for the high power and a rotation lock tab for the standard power.

• A needle bearing and thrust plate have been assembled in the front stationary gear for regulation of the eccentric shaft end play.

1
Stationary gear (standard power)
2
Main bearing
3
Front stationary gear
4
Rear stationary gear
5
Rotation lock tab
6
Plate
7
Needle bearing
8
Thrust plate
9
Screw (high power)